当前位置:PRODUCT

Herringbone belt

2013/11/22 8:47:40    
更多


Herringbone pattern characteristics: there are higher than the belt body on the surface of the "people" word pattern, pattern but speak but closed, and each kind of decorative pattern can be divided into high, medium and low three. Apply to 40 degree Angle or less powder, granular, small piece of material transportation, can also be packaged material.

Herringbone pattern conveyor belt is a kind of decorative pattern conveyor belt, there are higher than the belt body on the surface of the "people" word pattern, pattern but speak but closed, and each kind of decorative pattern can be divided into high, medium and low three. Apply to 40 degree Angle or less powder, granular, small piece of material transportation, can also be packaged material. With the decorative pattern due to the reasonable design is widely used in ports, metallurgy, mining, electricity, coal, foundry, building materials, food, fertilizers, and other fields material transfer.

Conveyor belt storage methods:

Conveyor belt to transport storage use, if there is improper, will delay the service life of short conveyor belt, will lead to worse conveyor belt breakage, can't normal use, so we have to know the correct use of conveyor belt, and some commonly used specifications:

1, the conveyor belt in transportation and storage, should be kept clean, avoid direct sunlight, rain soak pipe, prevent with acid, alkali, oil, organic solvent, affecting the quality of rubber material such as contact and distance heating device 1 metres away.

2, storage room temperature should be keep between 15 - + 40, should maintain between 50-80% relative humidity

3, conveyor belt running speed should not be commonly more than 20.5 m/s, large transport blocks of abrasion resistant materials and using fixed plough type discharging device should be used as far as possible at low speed. Within the prescribed speed, will influence the service life of the tape.

4, storage, conveyor belt must be placed in rolls, not folding, should be placed during quarterly turn once.

5, to reduce the material impact to the tape and wear and tear, the feeding direction should be along the belt running direction; Material falling onto the tape head should be to reduce as far as possible; Micro feeding mouth to avoid roll or roller spacing and buffer action. To prevent scraping the broken belt, keep-off device, scraper cleaning device, and discharging device with the contact part of the tape should adopt suitable rubber stiffness, do not use with layers of glue to take the lead.

6, conveyor transmission drum, and the relationship between transport layers and the diameter of drive roll micro redirection roller and the roller groove Angle, should according to the regulations of the design of the conveyor, reasonable selection.